Just like everything does eventually wear out so that the treadmill. You can see that it must be worn and in need of replacement, if slows down when you step on them when torn or if there wavy edges. Actually, the tape must be replaced must first examine whether the bridge is in order. If so, then it can only lubrication or waxing. If the cover worn on the hand, as channels or shows other signs of wear, such as the bridge and shows the belt should be replaced. If there is onethe belt to be replaced, then check your manual for instructions. Most bands have a generic set of instructions, but the manual will tell you the correct way to replace the belt for your system.
To replace the belt to pull the plug to prevent electric shock. If you disconnected the cable to remove the cover or on the bonnet. Locate the screws that adjust the belt tension and press the roller to the bridge. Remove the roll and the first frontthen remove the rear roller. If the treadmill is a slippery slope and it is difficult to remove the pin positions, only to move out there and play again. Remove the tape in one piece. Remove in one piece will remind you how to install the new one. Locate the screws that hold the bridge together. Remove and remove the old bridge and the belt. Now it's time to wax fat and the bridge. Look at your new belt should be installed by a seam must be left to the bottomright. An indicator on the tape that the direction the belt should show you around, there is usually provided by the manufacturer. Slide the tape and put it back on deck. Pull the front roller and then roll back. Make sure the belt fits. When the treadmill is running when you try to take while trying to stop him, then go back and correct until everything fits perfectly and comfortably.
0 comments:
Post a Comment